It all depends on the configuration but you likely have a button that activates the door operator.
Stanley garage door opener opens on its own.
To troubleshoot the garage door opener button make sure it s clean and free of debris.
If the motor overload protector has been activated wait 10 minutes for the motor to cool down.
Then look to see if the rollers are in working order.
The button can easily get dirty and stuck in the pushed position.
Garage door openers operate on one of many frequencies and while it is possible.
Garage doors use radio frequencies to open and close.
A garage door that randomly opens by itself is not a common problem but does occur from.
If your stanley garage door opener will not work ensure that it is plugged into a live 120 volt outlet.
Safety sensors are the electronic eyes near the base of the door track on both sides.
Whether you re using the passcode entry the buttons inside the garage or your remote opener the openers and the garage door itself must be on the same frequency.
This will cause the door to open and close until the button becomes unstuck.
Button button the spruce.
They need to have a clear line of sight between them in order for the door to work properly.
A garage door opener operating on its own may be caused by several problems.
Erase all codes in your remote and then reprogram it.
Keep in mind that the remote control will not operate the door until the beam sensor has been attached and properly aligned.
Today the range includes over 7 500 builders hardware products.
Opens and closes by itself when your garage door opens or closes when you haven t triggered the remote one possible cause is that a neighbor s remote was programmed at the same time as yours.
Verify if there isn t a block between them.
The door operator button is similar to a door bell.
For one of your neighbors remotes to open your garage door it is highly unlikely.
The stanley works was established by frederick t.
Originally it manufactured a wide range of door hardware including hinges and bolts.
First you should check the safety sensors.