Step By Step Roofing Installation

The following 8 instruction steps will guide you through the installation of a metal roof.

Step by step roofing installation.

Getting the right result will help you determine the right amount of metal roofing material you ll need to order. Measure the roof area. You first measure the roof s width and length then add the desired overhang measuring from the lowest. Ice and water shield sticks to the wood decking which prevents any water leaks.

It stops water from getting through to the roof at. During a diy roof installation job paying attention to manufacturer s directions is of the utmost importance. Next install your vent or stack flashing over that row of shingles photo 13. Ice and water shield installation next step is installing ice and water shield which is a special type of roofing underlayment.

Step by step roll roofing installation. Start by installing the edges. Install the shingles up and halfway past the vent hole or stack. The first step to installing a metal roof is to take an accurate measurement of your roof s height length and width.

The washer under the screw head should seal to the surface of the panel without bulging or shifting. Install shingles from the lower left corner working to the right and also working up the roof slope. Add an insulation layer so that it traps moisture between the sheathing and the metal roof. Arrange the shingles so the ends and the.

Secure the roofing felt using a staple gun. This involves another four steps. Place the first screw about 7 inches from the bottom and each subsequent screw about 18 to 24 inches apart along the vertical run. Install the roofing screws vertically along each rib in the panel.

Seal the top nail holes and continue on up with your shingles. Install a drip edge around the perimeter of the roof. Use the 1 25 inch nails to secure the metal strips on the flashing. You will need to order enough metal material to cover the entire roof and this process starts with measuring the full size of your roof in square feet.

Secure the screws but do not overtighten. The above roof installation steps are intended to give you a basic guideline to install new roofing materials. It must be installed at the bottom of the roof and at all roof penetrations chimneys pipe flanges roof connections etc. Installing the roof.

This aluminum flashing protects the edges of the roof sheathing from water. Nail it down with your roofing gun top and bottom. The type of materials used will greatly affect the method of roof installation.